Search results

Jump to navigation Jump to search
  • ...her 999 models is attributed to the top end changes where more extreme cam-timing is countered by oversized [[titanium]] valves with reduced diameter stems o ...lve collets, 12-hole racing injectors, magnesium head covers, carbon fibre timing belt covers with vents and a carbon fibre silencer heat shield.
    5 KB (742 words) - 18:22, 22 February 2009
  • ...of using [[pushrod]]s. This arrangement is more complex, and relies on a [[timing belt]] or chain, but allows for greater valvetrain flexibility. Many OHC engines today employ [[Variable Valve Timing]] and [[multi-valve|multiple valves]] to improve efficiency and power. OHC
    5 KB (694 words) - 08:50, 8 October 2009
  • ...ed on the top of the engine, the equivalent of the modern distributor. The timing of the spark was adjustable by rotating this mechanism through a lever moun ...e angle can be changed a small amount dynamically, allowing the ignition [[timing]] to be automatically advanced with increasing [[revolutions per minute]] (
    15 KB (2,376 words) - 14:22, 24 September 2009
  • ...es per cylinder, DOHC, chain driven camshafts, continuously variable valve timing system both for intake and exhaust
    2 KB (284 words) - 11:38, 8 October 2009
  • === Valve Timing === === Desmodromic valve timing ===
    12 KB (1,944 words) - 22:56, 14 June 2009
  • Many OHC engines today employ [[Variable Valve Timing]] and [[multi-valve|multiple valves]] to improve efficiency and power. OHC
    4 KB (549 words) - 18:19, 17 July 2009
  • |Motor || three-cylinder in the stellar system, the timing OHV OHC
    2 KB (288 words) - 22:18, 13 October 2010
  • ...s and run on lower octane standard fuel) but with more aggressive camshaft timing (in an effort to reclaim some of the power lost through the reduction in co
    4 KB (664 words) - 10:13, 26 May 2009
  • ...d manual transmission. One major difference in this engine was its use of timing belts rather than chains.
    4 KB (611 words) - 08:24, 15 July 2009
  • ...the addition of variable valve timing and knock sensors to delay ignition timing, it is possible to manufacture gasoline engines with compression ratios of ...ssion ratio, or in this case between 150 psi and 200 psi, depending on cam timing. Purpose-built racing engines, stationary engines etc. will return figures
    16 KB (2,479 words) - 14:53, 25 September 2009
  • ...4 valves per cylinder]] with [[variable valve timing|continuously variable timing]]
    6 KB (913 words) - 00:27, 14 October 2009
  • ...2, Stanley Webb riding a 5hp Triumph had to stop at St. Johns to adjust a timing-belt and retired on lap 3 with a problem with the engine exhaust-valve. At
    6 KB (833 words) - 15:25, 22 February 2009
  • ...nder blocks also being used. There's a new intake manifold, revised intake timing, a low counter-pressure exhaust silencer and re-positioned valve-springs, t
    4 KB (674 words) - 08:58, 4 August 2009
  • ...because the engine was always "full throttle", and also because the valve timing was often less than ideal. The rotating mass of the engine made it, in effe ...more "bangs per minute" meant more power delivered. Improvements in valve timing, ignition systems and lighter materials made these higher RPM possible, and
    12 KB (2,030 words) - 18:09, 14 September 2009
  • ...turbo diesel. The 1962cc injection also incorporated a variable camshaft timing system.
    4 KB (462 words) - 23:20, 27 August 2010
  • ...s with a red pin-stripe, Pirelli tyres, plus carbon fibre fork protectors, timing belt covers, front fender and tail/ exhaust side panels. These upgrades mad
    5 KB (762 words) - 00:04, 4 March 2009
  • ...piston port type engines. The two-stroke piston port type engine's intake timing opens and closes before and after top dead center at the same crank angle ...the exhaust port by closing off the top part of the port which alters port timing such as [[Yamaha]] YPVS, [[Suzuki]] AETC system or by altering the volume o
    19 KB (3,049 words) - 09:48, 2 August 2009
  • ...]. The Barchetta has 1747 cc dohc petrol engine fitted [[variable camshaft timing]], for the first time in Fiat production car. The engine has 131 PS and 164
    5 KB (648 words) - 10:04, 2 November 2009
  • ...ation tables stored in the ECM/ECU, it controls the amount of fuel and its timing (the "start of injection") through electric or hydraulic [[actuators]] to m ...the start of injection or "timing" is said to be 10 deg BTDC. The optimal timing will depend on both the engine design as well as its speed and load.
    33 KB (5,114 words) - 23:11, 23 September 2009
  • ...d manual transmission. One major difference in this engine was its use of timing belts rather than chains.
    4 KB (610 words) - 18:56, 11 November 2009
  • ...ano, and Cristiano were showing great interest in the family business. The timing could not have been better as the demand for De Rosa bicycles skyrocketed i
    6 KB (1,076 words) - 16:07, 16 April 2009
  • ...er more) between runs, average gradient of the racing surface not over 1%, timing gear accurate within 0.01sec, and cars must be [[drive wheel|wheel-driven]] |125.94||202.68||115.93||186.57||first run using electronic timing
    16 KB (1,910 words) - 09:30, 26 July 2009
  • ...e aerodynamics, an optimised (higher compression ratio and different valve timing) 1301 cc engine (rated at 65 bhp), an engine shut-off system (when idling)
    4 KB (608 words) - 16:51, 31 October 2009
  • ...ar (1993) with the ''Mito II Replica'' is a new endeavor of the [[ignition timing]], which is advanced by 1 mm to 1.55 mm, because the new engine. ...he engine to adapt to the new carburetor, have a setting of the [[Ignition timing]], which is anticipated to be 1.55 mm to 1.85 mm, from freshman 8P022547'''
    28 KB (4,585 words) - 16:35, 13 June 2009
  • ...with the engine [[RPM]], also the valve lift varies. See [[variable valve timing]].
    5 KB (840 words) - 08:50, 8 October 2009
  • ...es. Most [[OHC]] engines drive the [[camshaft]] or [[camshaft]]s using a [[timing belt]], a [[Roller chain|chain]] or multiple [[Roller chain|chain]]s. These
    8 KB (1,302 words) - 08:11, 14 June 2009
  • ...ential Electronic Fuel Injection]]. Most versions feature [[variable valve timing|continuously-variable cam phasing]] on both intake and exhaust valves and e
    8 KB (1,122 words) - 14:35, 15 June 2009
  • for an ignition timing system], [[1898]]), Richard Simms (GB 24859/1898, 1898), and Robert Bosch ( ...as though the ignition timing was retarded, and a large one as though the timing was advanced.
    23 KB (3,923 words) - 22:48, 11 June 2009
  • ...that a trained operator will be shifting gears in a known coordination of timing. Commercial vehicle operators use a [[double clutch|double-clutching]] tech
    9 KB (1,293 words) - 23:27, 3 July 2009
  • Timing gear: 5 valve/cyl (3 intake, 2 exhaust), 4 overhead camshafts (2 per cylind ECU: Bosch Motronic 2.7 (controls the fuel feed, ignition timing, and variable length intake and exhaust systems)<br>
    9 KB (1,292 words) - 00:20, 14 October 2009
  • ...d manual transmission. One major difference in this engine was its use of timing belts rather than chains.
    5 KB (737 words) - 00:13, 14 October 2009
  • ...open [[Spyder]] ''GTS''. The American version had an exhaust air-pump, and timing changes which created 175hp. The GT had 3 Weber 40 DCNF/6 or 40 DCNF/7 carb ...luminum alloy. The compression ratio was 8.8:1. The American version had a timing change and an air-pump which produced a modest 230hp. The GT4 weighed 2535
    12 KB (1,778 words) - 07:21, 29 April 2016
  • ...rakes and things like sealed cooling systems, thermatic fans and a toothed timing belt for the motor. AC 124 coupes gained small changes each year e.g. - an
    8 KB (1,197 words) - 16:32, 5 March 2009
  • ...ve featured in production cars are not allowed, including [[variable valve timing]], [[Variable Length Intake Manifold|variable intake geometry]], [[Anti-loc
    10 KB (1,242 words) - 17:04, 14 March 2009
  • ...of [[multi-valve|multiple intake and exhaust valves]] and [[variable valve timing]]. Most cam-in-block engines have two valves per cylinder, while many moder
    10 KB (1,635 words) - 08:54, 4 August 2009
  • ...the A3/C one of the first front-mid-engined cars ever built. To adjust the timing you actually had to take out a piece of the dash! Both cars were being buil
    10 KB (1,689 words) - 11:41, 22 March 2009
  • ...r brakes, the long-overdue addition of ABS brakes and a new variable valve timing system on the 5.7 litre V12 were the only updates. Power output increased t ...in addition to new intake and exhaust systems and a refined variable valve timing system with slightly less aggressive camshafts than had been used in the GT
    13 KB (2,003 words) - 21:53, 2 June 2010
  • ...r head which incorporated hemispherical combustion chambers, altered valve timing, new inlet and exhaust manifolds as well as different carburation. These mo * In ''[[Bad Timing]]'', the character played by [[Art Garfunkel]] drives a red Lancia Beta Spi
    19 KB (2,841 words) - 01:39, 12 December 2011
  • ...changes, after a year's absence, are once again allowed during pit stops. Timing pitstops with reference to other cars is crucial - if they are following an
    11 KB (1,849 words) - 00:06, 8 August 2009
  • ...version was the first mass manufactured DOHC to utilize reinforced rubber timing belts, an innovation that would come into nearly universal use in the decad
    6 KB (818 words) - 01:08, 22 February 2011
  • ..., [[Italy]] was just emerging from a rather severe economic slow-down. The timing was just right and as it turned out the small [[Cherasco]] factory was havi
    7 KB (1,219 words) - 10:40, 3 May 2010
  • ...d 4-cylinder Twin Spark (150-155 bhp) 16 valve engines with variable valve timing, along with the 1.9 L (105-150 bhp) and 2.4 L (136-175 bhp) JTD turbodiesel
    7 KB (978 words) - 09:15, 22 October 2009
  • ...] parts. It has three separate computers that ran the car by adjusting the timing and fuel delivery depending on octane rating and a knock sensor feed back.
    8 KB (1,154 words) - 09:11, 21 November 2011
  • ...up to 75.2&nbsp;mm for 5998&nbsp;cc total displacement. [[Variable valve timing]] was added on both intake and exhaust. Normally-aspirated once again, the
    14 KB (2,144 words) - 23:23, 21 September 2008
  • ...ision to move from Ferrari to Lotus seemed like a natural one. Reutemann's timing was off, however, and he struggled while [[Jody Scheckter]] won the title f
    13 KB (1,957 words) - 22:33, 23 September 2009
  • ...n the Cayenne features modifications to the head as well as the intake and timing systems.
    13 KB (2,025 words) - 21:40, 16 July 2008
  • ..., decided not to return and so Brundle got the drive. It was a case of bad timing in many ways. McLaren were on the cusp of a downturn and throughout 1994 we
    15 KB (2,120 words) - 14:05, 13 April 2009
  • ...otivated, in fact the bike was tested with [[Kenny Roberts]], showing good timing.
    13 KB (1,976 words) - 19:14, 4 May 2009
  • ...e of two ways, either they alter the exhaust port size (and therefore port timing) such as Suzuki AETC system or alter the volume on the exhaust, such as Hon
    15 KB (2,394 words) - 23:48, 11 September 2009
  • ...of [[multi-valve|multiple intake and exhaust valves]] and [[variable valve timing]]. Most cam-in-block engines have two valves per cylinder, while many moder
    11 KB (1,698 words) - 08:59, 8 October 2009

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)