Search results

• Bugatti Model 100
  ...e push rod operated with one section threaded to fit into the next. A trim crank in the cockpit screws the rod section in or out through a chain and sprocke
  3 KB (475 words) - 11:02, 20 September 2009
• FAST
  ...linder engine and 2991 cc, with valves in the head, three marches forward, crank and piston aluminum, and 80 hp power at 4500 rpm.
  2 KB (344 words) - 13:13, 8 July 2010
• Controlled Combustion Engine
  * [http://www.autofieldguide.com/articles/050302.html Cams Replace Crank in new Engine Design] from Automotive Design & Production.
  3 KB (487 words) - 22:32, 23 September 2009
• Straight-3
  Most straight-3 engines employ a crank angle of 120° and are thus rotationally balanced; however, since the three
  2 KB (349 words) - 12:22, 8 October 2009
• Linkage (mechanical)
  * Crank-slider, (four-bar, one DOF) ...nsions]] and [[bolt cutters]]. The internal combustion engine's piston/rod/crank is a classic four-bar linkage with one degree of freedom. Linkages are ofte
  11 KB (1,625 words) - 08:47, 15 June 2009
• Mignon
  File:Mignon valve cover.jpg | Mignon engine crank cover
  4 KB (626 words) - 14:30, 27 November 2016
• Ignition system
  ...ms do away with the distributor as a timing apparatus and use a magnetic [[crank angle sensor]] mounted on the crankshaft to trigger the ignition at the pro ...ming and [[firing order]]. Primary sensors on the system are engine angle (crank or Top Dead Center (TDC) position), airflow into the engine and throttle de
  15 KB (2,376 words) - 14:22, 24 September 2009
• List of Manufacturers
  *[[Crank Brothers]] [http://www.crankbrothers.com/]
  6 KB (665 words) - 11:39, 8 October 2009
• Forced induction
  ...rque generated from the rotational mass internal to the engine through the crank pulley. A turbo relies on the volume and velocity of exhaust gases to spoo
  5 KB (791 words) - 09:19, 7 October 2009
• MV Agusta F4 series
  ...tag of 100,000 €. The engine is a 1,078 cc big bore edition with valves, crank and piston rods made from [[titanium]] based on the F4 1000 R engine combin
  16 KB (2,337 words) - 23:08, 24 February 2009
• V8
  ...ane''' V8 is the typical V8 configuration used in American road cars. Each crank pin (of four) is at a 90° angle from the previous, so that viewed from the * The '''flat-plane''' V8 design has crank pins at 180°. They are imperfectly balanced and thus produce severe vibrat
  17 KB (2,591 words) - 00:05, 8 August 2009
• Four-cylinder
  ...park plug]] (darker-grey), a [[piston]] (yellow) and a [[crank (mechanism)|crank]] (purple). A single sweep of the cylinder by the piston in an upward or do ...eciprocating force through a specially designed bearing assembly to turn a crank mechanism. Intake, compression, power, and exhaust all occur in each stroke
  22 KB (3,344 words) - 22:07, 11 August 2009
• Non-synchronous transmission
  Any transmission that requires the operator to manually synchronize engine crank-shaft revolutions (RPM) with drive-shaft revolutions is non-synchronous.
  9 KB (1,293 words) - 23:27, 3 July 2009
• Two-stroke cycle
  ...take timing opens and closes before and after top dead center at the same crank angle making it [[symmetrical]] whereas the disk rotary valve allows the op :Crank is at 0 or 360°.
  19 KB (3,049 words) - 09:48, 2 August 2009
• Bicycle gearing
  ...termine that a human can deliver maximum power only over a narrow range of crank rotational speed or ''[[Cadence (cycling)|cadence]].'' To match the [[power ...tios they also need to know the length of the pedal cranks in millimetres (crank lengths are normally some multiple of 2.5 mm). If the bicycle has an enclos
  24 KB (3,509 words) - 23:29, 3 July 2009
• Ducati V-twin
  ...to this day, in air and liquid cooled form. The Mille used a plain bearing crank, like the belt models. ...ven valves|belt driven camshaft engines]], instead of the old ball bearing crank, [[Ducati V-twin motorcycles#Bevel gear driven valves|bevel geared shaft dr
  22 KB (3,665 words) - 13:08, 18 April 2009
• Internal-combustion engine
  ...park plug]] (darker-grey), a [[piston]] (yellow) and a [[crank (mechanism)|crank]] (purple). A single sweep of the cylinder by the piston in an upward or do ...eciprocating force through a specially designed bearing assembly to turn a crank mechanism. Intake, compression, power, and exhaust all occur in each stroke
  20 KB (3,085 words) - 13:24, 8 October 2009
• Four-stroke
  ...lower runs in (as opposed to following the outside profile only), others a crank arrangement similar to the crankshaft. The drawback of the system is its in
  11 KB (1,765 words) - 11:04, 10 November 2005
• Internal combustion engine
  ...park plug]] (darker-grey), a [[piston]] (yellow) and a [[crank (mechanism)|crank]] (purple). A single sweep of the cylinder by the piston in an upward or do ...eciprocating force through a specially designed bearing assembly to turn a crank mechanism. Intake, compression, power, and exhaust all occur in each stroke
  40 KB (6,068 words) - 09:48, 2 August 2009

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)