Search results

• Parasitic loss
  ...uces parasitic loss. For instance, a [[dry sump]] improvement over a [[wet sump]] results in lower parasitic loss. The reason may be less friction or many
  2 KB (243 words) - 08:26, 8 October 2009
• Lamborghini V10
  ...the [[center of gravity]] of the engine low. For the same reason, a [[dry-sump]] lubrication system was also used. ; Lubrication system: dry sump
  2 KB (284 words) - 11:38, 8 October 2009
• Salve
  ...d, side valve of 45 mm, the lubrication had a double pump and an automatic sump motor cross section, three-speed gearbox in the block, double cradle frame
  977 bytes (137 words) - 15:55, 19 April 2010
• Aprilia RXV
  ...12.5:1 compression ratio. RXV/SXV 5.5: 549 cc twin-cylinder 77° v-twin dry sump water cooled four stroke with 12:1 compression ratio. ...r cylinder. The 77 degree cylinder angle minimizes vibration. Both are dry sump, with a separate oil tank for the gearbox and engine.
  3 KB (462 words) - 17:35, 13 October 2009
• Imperia motorcycle
  ...eled [[gears]] and sapling. In 1954 came the last change to the block. The sump was changed with generous cooling fins, and completely redesigned [[cylinde
  2 KB (272 words) - 10:06, 28 November 2010
• Maserati GranTurismo
  ...ion is located in the front of the vehicle, as opposed to a [[Dry_sump|dry sump]] and a rear-mounted transmission used on Duo Select models of the Coupé a
  5 KB (560 words) - 08:06, 19 October 2009
• Innocenti Regent
  ...egro used [[front-wheel drive]], using the familiar A-Series engine with a sump-mounted transmission. The higher-specification models used the [[SOHC]] E-S
  4 KB (542 words) - 13:15, 28 January 2009
• Autobianchi Primula
  ...trary to similar BMC models, which had the transmissions in the [[sump|oil sump]], the Primula had its four-speed [[manual transmission]] placed end-on, an
  5 KB (776 words) - 09:19, 28 September 2012
• Bandini 1000 GT
  ...ings , oblock and [[base]] to five [[media bench]] in a single casting and sump alloy of aluminum, cylinders dismantled.
  4 KB (501 words) - 22:28, 23 September 2009
• Ferrari 512 Berlinetta Boxer
  ...ngine was larger at 4942 cc, but power was off to 360 hp. [[Dry sump lubrication]] was used for a lower center of gravity. External differentia
  4 KB (611 words) - 08:24, 15 July 2009
• Aspes
  ...ticularity of a double inlet, obtained in part through a reed valve on the sump and, in part, through the motion of the piston. The power was 20 hp at 9600
  3 KB (473 words) - 01:03, 7 February 2011
• Ferrari 250 GT Drogo
  ...to the center of the chassis than the GTO, and lowered it by fitting a dry sump system.
  3 KB (385 words) - 15:46, 12 September 2010
• Bandini 750 sport internazionale
  * Materials and particularity: [[base]] 5 [[media bench]] and alloy sump of 5 litres capacity, [[head]] alloy [[DOHC]], Distribution gear double ove ...emisphere, block and [[base]] five [[media bench]] unique fusion of alloy, sump in reeds of cylinders in [[iron]] chrome and detachable
  9 KB (1,217 words) - 22:27, 23 September 2009
• FF layout
  ...had the engine laterally mounted (east-west), with the transmission in the sump below the crankshaft. This was just about as good as one could do to put th
  3 KB (562 words) - 09:02, 8 October 2009
• Bandini 1000
  ...re, block and [[base]] to five [[media bench]] unique fusion of aluminium, sump in [[aluminium alloys | Light]], reeds of cylinders in [[iron]] chrome and
  4 KB (615 words) - 22:30, 23 September 2009
• Alfa Romeo Montreal
  ...ent from the original, using a 2593 cc 90° [[dry-sump lubrication|dry-sump lubricated]] [[V8]] engine with [[SPICA]] (Società Pompe Iniezione Cassani
  7 KB (1,031 words) - 16:29, 22 October 2009
• Ducati Apollo
  ...ing]] big ends. That [[crankshaft]] fitted into a horizontally split [[wet sump]] [[crankcase]] with a centre main bearing support. The bore was 84.5  *Oil sump capacity 3.5 quarts
  6 KB (964 words) - 09:00, 7 October 2009
• Front-wheel drive
  ...rised by the [[Mini]] of 1959; there the transmission was built into the [[sump]] of the engine, and drive was transferred to it via a set of primary [[gea ...e, used a substantially different arrangement with the transmission in the sump of the engine.
  12 KB (1,842 words) - 23:38, 7 August 2009
• Bandini s.p. 1000
  ...ngs, monoblock and [[base]] to five [[media bench]] in a single fusion and sump alloy of aluminum, chrome pipes of cylinders and to dismantle, aluminium ro
  5 KB (655 words) - 22:30, 23 September 2009

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)