Search results

Jump to navigation Jump to search
  • ...n redefining conventions of luxury. Primarily responsible for this was the mechanical refinement and overall dimensions of the motor car. **Front : beam axle with leaf springs
    14 KB (2,091 words) - 23:37, 24 March 2010
  • ...t rodder at heart his patience wisdom and depth of knowledge of all things mechanical continues to amaze me.
    16 KB (2,726 words) - 23:22, 7 February 2011
  • “The proportions of the Visconti are indeed substantially diverse, as is the mechanical arrangement, a V6 rather than a V12 engine. Placed clearly in evidence is a Comfort is assured by the suspension pneumatic springs, which also enable the electronic control of the height from the ground, wh
    9 KB (1,490 words) - 13:31, 8 October 2009
  • Body lean can also be controlled by the springs, anti-roll bars or the roll center heights. ...suspension springs. Jacking is frequently done with screws or shims at the springs.
    36 KB (5,845 words) - 08:04, 8 October 2009
  • | Front suspension = Independent suspension, pushrod activated torsion springs ...st podium of the season. Massa, meanwhile, started from tenth place, after mechanical problems prevented him from setting a time in the third qualifying session.
    13 KB (2,041 words) - 19:21, 28 April 2012
  • The earliest automotive transmissions were entirely mechanical unsynchronized gearing systems. They could be shifted, with multiple gear r ...hen shift into first and start up again. With continuing sophistication of mechanical development, however, fully synchromesh transmissions with three speeds, th
    40 KB (6,454 words) - 10:28, 15 July 2009
  • == Mechanical features == ...brakes on all four wheels. The rear suspension uses a beam axle with coil springs. [[Air conditioning]] and a [[limited slip differential|limited slip rear d
    34 KB (4,853 words) - 12:32, 13 January 2013
  • ...pension with dual-rate dampers and helicoidal springs, with the struts and springs set slightly off-centre. ...ile the damper rates, front and rear toe-in and the relative angle between springs and dampers have all been altered. The steering retains the rack and pinion
    34 KB (4,989 words) - 17:46, 6 November 2012
  • ...e]] suspended on [[leaf spring]]s. Later versions of the car added various mechanical improvements but this spirit of robust simplicity was adhered to throughout ...gid rear axle (known as the 'Omega' axle) with a central mounting and coil springs. The 4x4 retained the old leaf sprung set-up, presumably to avoid having to
    37 KB (5,681 words) - 09:17, 18 November 2009
  • Drifting outside Japan "officially" began in 1996 with an event at [[Willow Springs]] racetrack in [[California]] hosted by the magazine Option. Inada, the [[ ...such cases more passes may be run until a winner is produced. Sometimes mechanical failure determines the battle's outcome, either during or preceding a heat.
    28 KB (4,495 words) - 07:58, 4 August 2009
  • The front suspension generally consists of sliding steel tubes with long springs inside called ''[[fork tube|forks]]'' which use hydraulic fluid for damping .... A lever on the handlebar, through a cable or hydraulic arrangement, uses mechanical advantage to release the clutch spring, allowing the engine to freewheel wi
    38 KB (6,073 words) - 20:26, 6 July 2009
  • ...features included a [[flywheel]], [[brake]], [[gear box]], and [[Bearing (mechanical)|bearing]], which are also the features of a modern automobile. His design By the 1930s most of the mechanical technology used in today's automobiles had been invented although some thin
    29 KB (4,330 words) - 12:07, 23 January 2009
  • ...arm have been designed for a wider rear tire (140/80-17 bias-ply), revised springs in the rear shocks, more seat padding. Black with red, black with gold, se ...ring, lower fairings with chrome crash bars, wire wheels, retro taillight, mechanical odometer and tripmeter, floorboards, spoked wheels, chrome mudguards, throt
    17 KB (2,259 words) - 08:42, 8 October 2009
  • ...x]] assembly. Solid [[axles]] were used, suspended by semi-elliptical leaf springs. The 8C 2300 came in two [[wheelbase]]s, Lungo of 3,100mm used for 4-seater
    22 KB (3,314 words) - 20:56, 24 March 2010
  • ...es and any other activity in relation to or connected to metallurgical and mechanical industry". ...posted the fastest lap time, it often failed to complete races because of mechanical problems. Ultimately, the V8 was not developed further as Moto Guzzi withdr
    53 KB (7,792 words) - 12:53, 9 December 2009

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)